Plotter cut your design in reverse and then weed out the excess material.

Ensure the design you are going to sublimation print is sized correctly and printed in reverse.

Sublimation print your design onto your sublimation paper. If you need to trim round your sublimation paper to aide alignment later in the process do this now.

Pre-press your garment.

Place the weeded transfer onto your garment (now with your design facing you) and align as necessary.

Heat press the transfer with a medium even pressure at 150C for 5 seconds, then peel the PET release liner hot / warm / cool.

 

Alternatively set your press to 180C, and "tack" the transfer in place for 2 seconds.

Carefully align your sublimation paper over the transfer (print side down) and tape down a couple of the edges of your paper with heat resistant tape or application tape, to prevent miss-alignment when your press closes or to prevent lifting of the paper when your heat press rises.

Heat press at 180C for 20 seconds.  

Remove the Sublimation paper.

And you are done!

 

All information is given as guideline. We always recommend that you perform a test cut and print prior to production.