Err

Shop
Search Your Cart   Continue Shopping

Dae Ha HTV 3D Puff by the metre

(Code: 56PFM02102-DFU-02)
Colour :
£ 8.95
Add to cart
Dae Ha HTV 3D Puff by the metre
Dae Ha soft 3D Puff PU film which is perfect for fashion, party and leisure wear.

A clear, light adhesive backing enables fine cutting design and aides registration. Very easy to cut and weed.

Note that the Puff PU may not expand correctly if the design is cut too large. Please keep solid square /rectangular blocks below 40mm. We recommend testing prior to use as puffing results may vary depending on the heat press conditions.  

Suitable for cotton, polyester, mixtures of polyester/cotton and polyester/acrylic or similar textiles.
 
EN71-3:2019 Certified
Dae-Ha
  25+ 1+
All colours except neons
(51 cm wide)		 8.05 8.95
Neon Yellow and Neon Green
(51 cm wide)		 9.45 8.50
 
We offer discounts on total orders of over 25 metres (colours can be mixed) from the Dae Ha Puff 3D range. The discounted amounts will be shown in your shopping cart.  
 
This puff film can also be purchased in 29 x 51 strips for the Silhouette Cameo/Cricut and in 22.5 x 51 cm wide strips for the Silhouette Portrait.
  • White
    White
  • Black
    Black
  • Red
    Red
  • Orange
    Orange
  • Pink
    Pink
  • Turquoise
    Turquoise
  • Neon Yellow
    Neon Yellow
  • Neon Green
    Neon Green
We are authorised Silhouette distributors so check out our Silhouette page to see our range of these fantastic cutters!
APPLICATION INSTRUCTIONS
 
Cut your text or design in reverse and weed out excess film.

Set your heat press to 135°C.

Apply medium and even pressure across your transfer.

Press for 10 seconds.

Hot peel the release liner immediately and remove from the platen while giving the garment a shake.

All information is given as guideline. We always recommend that you perform a test cut and print prior to production.
 
WASHING INSTRUCTIONS
60°C standard. Can be tumble dried on a low setting and ironed inside out
Roll Width  510 mm
Film Thickness 80 micron 3D Puff PU film. (Unpressed) 60 micron hot melt adhesive. Tolerance +-10 microns.
Storage Conditions Store in an upright position, away from direct sunlight. 10°C to 25°C
Layering No
Sublimation printable No